SMTP Test

    Q1. Type of EV charger you are having installed?

    Q2. Type of residence?

    Single Detached HomeTown HouseCondoSingle Family with Secondary SuiteOther

    Q2-1. If stratified, does your strata has a common electrical room supplying the power to your unit? Installer may need to get into the common electrical room.

    YesNo

    Q2-2. Do you have your own electrical meter in your residence?

    YesNo

    Q3. What is the rough square feet of the residence?(Living space only. not including garage or unfinished, non-dwelling areas)

    Q4. What's the Electric Service Power of your residence in Amps - Main break capacity?

    Unknown100 Amps125 Amps150 Amps175 Amps200 Amps

    Q5. Is there a secondary quite or secondary range? This is important for the electrician to do the load calculation needed for them to determine if there is enough power left in your home to get the permit needed to install the charger

    Q6. Location of the Panel of Subpanel where the breaker for the EV charger is located or will be installed?

    Inside attached garageInside detached garageMain FloorBasementSecond floorThird floorOutside carportOther

    Q7. Is there empty space in the panel/subpanel available to install the breaker (How many empty slots are available, at least 2 slots side by side must be available)?

    123Unknown

    Q8. Where will the EV charger be installed?

    Inside garageOutside garageCarportOther

    Q9. Is your residence EV ready? Meaning, it has already the breaker, wired and outlet needed for the charger. (i.e. For ChargePoint Home EV chargers you need a 40 Amps breaker, #8 wire to support the current going to the charger, and 208/240 V outlet.)

    YesNo

    Q10. What's the distance, in feet, between the panel/subpanel to the location where the EV charger be installed>

    Q11. In order to run a cable from the electrical panel to charger, will there be a need to cut through any walls? (i.e. If panel is in the main room and the installation location is inside the garage, the installer may need to drill a hole to get the wire from the main floor to the garage)

    YesNo

    Q11-1. If Yes, what type of material is involved?

    DrywallWood/StuccoBrickCinder BlockConcreteDrywall and Wood/StuccoOther

    Q11-2. How many walls the installer will have to drill holes to bring the electrical wire from the panel to the installation location? i.e. from basement to inside garage, the wire must be taken up to main floor (1 hole) and from the Main floor to garage (1 more hole) for a total of 2 holes

    12345more

    Q12. Will the charger be installed in a detached garage or outside the residence where underground cabling is needed?

    YesNo

    Q12-1. If Yes, please describe the surface that needs trenching. i.e. Grass, Concrete, Asphalt, Gravel, Other.

    Q12-2. How many feet of trenching are needed?

    Q13. Please provide any images that you may want to provide for a better understanding of the installation (This could include but not limited to: Floor Plan, drawing of the route for the wiring, location of the EV Charger, etc)

    Q14. Insert an image of the circuit breaker in your electrical panel.